Bedlam
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Wear Standards of Desulfurization Gypsum Ball Press Machine

Go down

Wear Standards of Desulfurization Gypsum Ball Press Machine Empty Wear Standards of Desulfurization Gypsum Ball Press Machine

Post  yangyang Tue Apr 29, 2014 1:39 am

Desulfurization gypsum ball press machine and the corollary equipment can press and pellet the desulphurization gypsum powders once and for all without adding any adhesive. It has high output and big hardness, so that it has been used in many power plant and cement plant and the effect is excellent. Desulfurization gypsum pressure ball machine is widely used in farming industry and other industries, it is composed of conveyor belt, ingredient machine, rotary dryer, stirring tank, and briquette machine.

Structure is simple, operation is easy,efficiency is high. This ball press machine can produce 100-200t/d desulfurization gypsum, finished products' shape is perfect. So it is favored by customers all over the world. Materials are sent to ingredient machine by belt conveyor for adding ingredient, then transfer to drying machine. After drying, materials are transferred into the double-shaft mixer for mixing, After mixing fully, enter into the briquette machine to press into ball. As balls have a lot of water, need to dry. After drying, the finished products are shipped into the bin for storage.

In general, desulfurization gypsum pressure ball machine working environment is poor, the work time is long, will cause varying degrees of damage, thus affecting the speed of production, but how can we know if desulfurization gypsum ball briquette machine has been scrapped, cannot continue to produce, the update of equipment? Following is wear standards of desulfurization gypsum ball press machine:

1. The pinion surface erosion rate should not be greater than 30% of the tooth thickness, ball press machine form a complete set of equipment on the surface of the wheel wear is greater than 25% of the tooth thickness can be used down surface, grinding to 1/2 should be scrapped.

2. The hollow shaft surface groove, flecked bureau or its round surface worn through to the hollow shaft variant, crack, and so on and so forth should be updated. (info@sinoftm.com)

3. The distortion deformation of gear ring flange should not be greater than 7.5 mm

4. Bearing wear more than a third of its thickness.

ore powder ball press machine: http://www.chinaftm.com/products/Ore-powder-ball-press-machine.html

yangyang
Gimp
Gimp

Posts : 3
Join date : 2014-03-15

Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum